Well I think he's saving up for his own set cause the plan is to keep these for another truck I'm getting.
Bagged NBS Thread (99-07c) Pics & Discussion 123123
- Thread starter Zach.
- Start date
Well I think he's saving up for his own set cause the plan is to keep these for another truck I'm getting.
Just have to make my mind up and do it. I have bad habit of not saving money. Lol
Sent from my iPhone 4s
Sent from my iPhone 4s
You guys with aftermarket overflows. Did you use 1/2" fittings and hose or 3/4" fittings and hose?
It was around here or gmfs
I got the tank from summit with
1 fitting being 3/8 one 1/2
3/8 line was for over flow vent and a short peice that went to the rad.
The 1/2 came off the bottom. It had this factory Tee on the truck. Cut all that off. Re Tee'd it and barley squeezed it back onto the water pump.
Sent from my SAMSUNG-SGH-I777 using Tapatalk
I got the tank from summit with
1 fitting being 3/8 one 1/2
3/8 line was for over flow vent and a short peice that went to the rad.
The 1/2 came off the bottom. It had this factory Tee on the truck. Cut all that off. Re Tee'd it and barley squeezed it back onto the water pump.
Sent from my SAMSUNG-SGH-I777 using Tapatalk
I found another post that he made. 3/8" for upper port and 1/2" npt to 5/8" barb for the bottom port.
Ya wasn't sure if that's what he was talking about or not... but thought it was close
Sent from my DROID RAZR M using Tapatalk 2
Sent from my DROID RAZR M using Tapatalk 2
Well I've decided to just use the switchspeed for now. They aren't releasing a Vu4 with threaded ports anytime soon from what I can tell. So I'm just using 3/8" Valves with hydraulic line, accuair switchspeed, and a avs digital gauge setup. I already bought some Slow downs/valve mufflers for cheap on eBay. I can put together a full Valve setup with hydraulic line for the cost of the vu4 by itself.