2piece driveshaft

So back to the thread. Looking for more info on the 2ps swap. Joey has a thread on fgtfs, just looking for additional info.
 
thats all the information i got also. i wanna know more about the whole carrier bearing deal.
 
2-pc driveshaft

In for info aswell, need to do this on mine..I already know I can get 2pc $72+tax :cheeky:
 
Also...do I need to change my pinion again when I drop to 8"? I am using the supplied shit from belltech currently.
 
2-pc driveshaft

Jared said:
Also...do I need to change my pinion again when I drop to 8"? I am using the supplied shit from belltech currently.
Click to expand...

I never messed with mine but all trucks settle differently, just have to measure it after you drop and see how bad it's off iirc
 
i wouldnt think so, most come with preset pinion angles that why when no one adjust them majority of the time its fine. djm doesnt come with a preset so you have to adjust them which is why i got it hoping i could get it where i needed to be.
 
Because I'm a nice guy
Here's a little bit of info
http://www.gmfullsize.com/forum/showthread.php?t=147080



EDIT: Colyn with 1pc
Colyn. said:
Im @ 8" and it rubs sometimes when I run very low PSI in my helpers but otherwise its fine.... All my crossmembers are notched and cab beat in alittle.

DSCN2384.jpg


downsized_0219021712b.jpg


You can kind of see my gas tank crossmember notched in this picture...
Click to expand...
 
Last edited:
2-pc driveshaft

All nbs ex cab same 2pc driveshaft or are the different?


Sent from a secure terminal using the classified military network
 
2-pc driveshaft

How much did that cost u? I'd rather have a smaller 1 piece than a pinion angle that's all over the place with a 2 piece


Sent from a secure terminal using the classified military network
 
You must log in or register to reply here.
Top Bottom