wierd, email them and see if there could have been a issue with the bulb with a loose connection inside. or switch bulbs side to side and see if it follows the bulb
My switchbacks from them did that. Sent a set back and they replaced. Did it again a week later. I took them apart and re soldered the connections inside the bulb. Was sketchy but it fixed them.i know the bulb clip on the one side keeps popping out, but thats just the housing. if i get a second ill swap sides to see if i get the same thing.
Need to dial the rear in a bit. Needs moar low![]()
Sent from my iPhone using Tapatalk
wierd, email them and see if there could have been a issue with the bulb with a loose connection inside. or switch bulbs side to side and see if it follows the bulb
i know the bulb clip on the one side keeps popping out, but thats just the housing. if i get a second ill swap sides to see if i get the same thing.
Already seen more pics of this than the gasser
Sent from Tapashit
Yup, need to reseal them unfortunately.Dat condensation lol
Make sure you hit em with a heatgun before resealing to get all moisture out. Don't cut em back open or anything, just dry em out, find the leak and seal itYup, need to reseal them unfortunately.
My switchbacks from them did that. Sent a set back and they replaced. Did it again a week later. I took them apart and re soldered the connections inside the bulb. Was sketchy but it fixed them.
Need to dial the rear in a bit. Needs moar low![]()
Sent from my iPhone using Tapatalk
first problem ive had with any of their lights. ill dig into it when i can.
and the CGM consensus is to go back to non tinted tails correct?