Slow RCSB bagged build
- Thread starter FTC
- Start date
Tukn4s would be the best to speak with. I bought a set but haven't installed the yet since the truck was for sale
I was talking to Brett about hiems. We worked out a deal but he said that its easier to go through Cody (unparalleled customs)
in short, they allow for better angles than a traditional TRE. They are also said to be bumpsteer eliminators
Lookin good dude, I want that front kit so bad - wish i could weld. Interested to see how it aligns once you get it all settled.
yes they will work, he's spoke with me before about some, but I got a better deal at the time from Brett.
Ffr will work lowered. When I ordered mine for my dmax,I ordered a set for a buddy 5/8 static 4wd used for track purposes. He wanted full sleeves not just heim ends. Tony is a good guy and got it all out very fast
Sent from my HTC One using Xparent BlueTapatalk 2
Sent from my HTC One using Xparent BlueTapatalk 2
I have a set of ffr tie rods for sale if anyone's interested, shoot me a pm. I would shootem down with wd40 when they squeaked and it would go away for pretty long. These coupled with mcG16+ spindles and ridetech coilovers was by far the best static setup I ran(zero bumpsteer, zeroed out alignment, great adjustable ride quality and however low you want) and I've been through quite a bit of combos. Actually it's all for sale if anyone's interested.
kay: Notches built, gave up on waiting for specialty suspension to make it right. Supposedly they sent it out for a 4th time(yeah right) 3 weeks ago, this company is pure garbage.
These are built from 2x3 rectangle tube 3/16 wall, looks like 1/8 wall would have been more than enough, these are way overkill. And I definitely misjudged the leg lengths, they will need to be cut way down. They are tiged @~160 amps used the pulser a little but ended up just going back to straight current. Pretty good size bevel was ground in as well for almost full penetration. Not the prettiest of welds cause I was running short on time, but all toes are tied in nicely.
All tacked up
Butt joint cover pass after one root layer
Inside fillet
Also added a little of artistic flair to them to stand out a little
These are built from 2x3 rectangle tube 3/16 wall, looks like 1/8 wall would have been more than enough, these are way overkill. And I definitely misjudged the leg lengths, they will need to be cut way down. They are tiged @~160 amps used the pulser a little but ended up just going back to straight current. Pretty good size bevel was ground in as well for almost full penetration. Not the prettiest of welds cause I was running short on time, but all toes are tied in nicely.
All tacked up
Butt joint cover pass after one root layer
Inside fillet
Also added a little of artistic flair to them to stand out a little
