Daniel's Denali

Well even though I got graduation money mods are slow since I have to make the payments. Mods will stay super slow until next year hopefully I should get a good job first year of out college with good grades. Until then no huge mods. Hoping when I get money I can do 22x10 forces

Sent from my SAMSUNG-SM-G900A using Tapatalk
 
Wondering if anyone would buy my Denali wood steering wheel so I could buy a new one. Nothing wrong with mine just a little worn

Edit: it's $500 on ebay. Lol nevermind

Sent from my SAMSUNG-SM-G900A using Tapatalk
 
Last edited:
Okay so yesterday I had graduation and was fixing a phone before. It ended up taking a little longer than expected so I was almost going to be late so I was uh in a little hurry... Wondering if anyone knew what was going on, my tire pressure monitor light came on and it says service TPMS. My front left tire no longer has a pressure reading. When I was in a hurry yesterday I was going a little over 120ish and I had to cut to avoid a car coming over and the wheel kinda folded in... Like skid for a second.

Sent from my SAMSUNG-SM-G900A using Tapatalk
 
Yeah I know it was dumb the truck is actually very smooth at that speed lol. Just had a car get in my way which is partly my fault for speeding so much. And ginger what you mean I only totalled one lol that was the only wreck that was my fault

Sent from my SAMSUNG-SM-G900A using Tapatalk
 
D1nman said:
How does one go about this

Sent from my SAMSUNG-SM-G900A using Tapatalk
Click to expand...

1.Turn "ON" the ignition, with the engine OFF.
2.Apply the parking brake. IMPORTANT: If the learn mode cannot be enabled, ensure the TPM system is enabled in the PDM.
3.Turn the exterior lamp switch from "OFF" to parking lamps 4 times within 4 seconds. A horn chirp will sound and the low tire pressure light will begin to flash indicating the learn mode has been enabled.
CAUTION: Over inflating tires may cause personal injury or damage to the tires and wheels. When increasing tire pressure do not exceed the maximum inflation pressure as noted on the tire sidewall.
IMPORTANT: If a horn chirp does not sound after 35 seconds for any of the 4 sensors, turn the ignition "OFF" to exit the learn mode and repeat the procedure from step 1.

4.Starting with the left front tire, increase or decrease the pressure for 8-10 seconds, or until a horn chirp sounds. The horn chirp may occur before the 8-10 second pressure increase/decrease time period has been reached, or up to 30 seconds after the 8-10 second pressure increase/decrease time period has been reached.
5.After the horn chirp has sounded, proceed as in step 4 for the next 3 sensors in the following order:


Right front
Right rear
Left rear

6.After all sensors have been learned, exit the learn mode by turning "OFF" the ignition.
7.After the learn mode has been exited, adjust all tire pressures to the recommended psi
8.After adjusting all tire pressures to the recommended psi, run the tire pressure check in the DIC to see that the correct pressure is listed.
 
You must log in or register to reply here.
Top Bottom