Alecks' hopes and dreams thread.
- Thread starter Alecks
- Start date
Gonna just throw mine on and see how it is. We don't really get shitty weather down here so I should be fine on that part. Gonna make sure the gaskets are good and everything gets sealed nicely.
Sent from my iPhone using Tapatalk
New bumper is on, 1.5" body installed (front bumper needs aligning but isn't off much), chrome handles will go in next Wednesday along with rear liners and exhaust probably Monday if my tip gets in.
Yay for mods! Lmao
Sent from my iPhone using Tapatalk
Yay for mods! Lmao
Sent from my iPhone using Tapatalk
:Shake:
Nick_5 or however it's spelled on here
More times than I can remember, apparently. Lol
Sent from my iPhone using Tapatalk
Chrome handles are installed. Exhaust going to be done Tuesday and getting the trans lines done at a shop to save me the headache. Not sure how I'm going to wire the e-cutout's wiring yet, I have yet to be able to find the firewall on this truck. Then again I haven't really looked hard enough. It has a 12v plug in (gross) but I'm probably gonna hard wire it to one of the 12v plugs and run the switch into my console or under my dash
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Firewall is by your feet. Trans lines are easy to do. Just need to carefully pry out the c-clips, they're a motherfucker sometimes
Passenger side. I believe there's a shield with two 10mm bolts. I could be wrong but they should be behind that.
They are but are in a super tight spot. Not sure what tool to use to get them off either.
Sent from my iPhone using Tapatalk
