Your vehicles as they sit now!
- Thread starter Chance
- Start date
4wd af up front lol
Sent from Tapashit
No need to narrow rear end, just pull the bedsides :read:
Looks good af tho dude, can't wait to see/hear her running again
all my friends drive subarus. i'm the only one with a truck. at least i fit in somehow. mines the green 05 next to the Silverado.
Ehhh pass side pokes like 1.5" and drivers side .5" so it'll have to be narrowed but thanks bro I can't wait either :shake:
Sent from Tapashit
Lol I saw that in your thread, idk why the rear ends on these trucks are always off. Yours is bad, mine's off but it's not even a half inch difference, but my old truck was like yours
did add another 1/2 inch spacer and a bit more trimming and it clears now. about 44.75 front 44.25 rear.
just gotta find some pipe to buy and get a guy to weld it to my existing muffler then i could just use clamps from there back.
just gotta find some pipe to buy and get a guy to weld it to my existing muffler then i could just use clamps from there back.
Last edited:
Perks of being the GM: washing your vehicle at work when it's slow
Now that both piles are clean, it has to rain in the next day or two. Just how it is.
Now that both piles are clean, it has to rain in the next day or two. Just how it is.
Found out the other day that when I hit that curbcurb back in September I cracked both notches and a small hairline crack in each side of the frame. We welded it all up with my dad's little Lincoln but it doesn't get hot enough to get good penetration on that metal. So I took it to my little bro's job this morning and had him weld it all up all the way around, inside and out. In other words, what I should have done 3 years ago when I put them in. Lol.
How it looks now
Sent from my SM-N900V using Tapatalk
