FFB's Milf-Slayer Build

Idk how well it'd work but I tinted the lights on my old truck with Krylon gloss black and clear for a while, then once I got tired of it I just used lacquer thinner and several rags to wipe it all away. I had scuffed them with a red scotchbrite before I sprayed them but it just took a good buffing with my walmart slow buffer and some rubbing compound and they came out looking brand freaking new. Might be worth a shot, idk how yours are done though.
 
yeah me either, some kid from fsc/gmfs that did them. id like to sell them to make some money but i think the third tail has some clear coming up or something i thought i saw some bubble cracks idk.
 
ive used gas to remove tint on tails before on my obs. But also did not care very much because obs tails. used lacquer thinner before too and works well

tapatalk sent via pos phern
 
You can completely sand them dull and polish them clear after. Then keep sealing them. Or do like tonneh said

Sent from pasta.
 
I've used aircraft decal and adhesive remover a few times. Make sure you don't get the paint stripper though cuz it'll eat plastic. With the decal remover, just spray it on and wipe it off right away a few times, then wash em with soapy water and wetsand any spots that might still have some black. Then clear and done.

Sent from my SM-N900V using Tapatalk
 
No doubt, just seems funny they are different prices. Still good prices though, depending on shipping he could get new lights for under $100.
 
fortplainman said:
plans will be for spring:

zone UCA's
FFR tie rods(purchased)
replace leaking rear shocks
colormatched front grill
colormatched front bumper back
hidden 20in curved lightbar behind bumper bar
billet grill insert
billet bowtie
stock tails(done)
colormatched handles
tow mirrors
pull moldings
colormatched rear bumper
single exit exhaust with 4-6x12 dual walled tip dumped a little over the rear axle.

other things for maybe list and things depending on maintenance:

smaller rear block for stance
new slotted rotors
SS braided front lines
new caliper if needed incase bleeder is siezed shut
fox coilovers(spec'd for bds lift like ~$1500 if i recall correctly)
correct retune from bbp
new abs sensor for left hub(rubbed on tire and rubbed through wire)(done)
rear drum recall
switchbacks/leds and projectors from fastheadlights.
sound system/double din
Click to expand...

just bumping my list. got some 4in blocks courtesy of james thanks again bud. will put on maybe this weekend.

if anyone has any rear shocks for sale for a 6in lift truck let me know, these ones are killing me right now. just need something to run in the winter.
 
was looking on rough country's site, thought i saw rear shocks for sale for like 100 bucks. might try and snag something up.

whats the part number on the Bilsteins? maybe ill try to see if they are reasonable since im going to try and get resi fox for the summer.
 
yeah just looking for something on the cheaper side that has the debris guard on them, only reason my shocks gave up because the rubber seal took a shit.
 
My bds shocks are leaking everywhere and theyre only about 6 months old, so dont try those ones. Lol
 
Last edited:
You must log in or register to reply here.
Top Bottom