00silvy's official 2000 Silverado Build thread
- Thread starter 00silvyON
- Start date
This. Will make my lift install way easier. As I wont need the NTD brackets, or TB's, or keys.
Yup. And the guy that makes them runs that setup on his 1000+ HP 4x4 would truck :laugh:
Plans are a go. Just finalizing shock/spring package.
Once all is completed, and here.
I will be doing a big, picture intensive write up on whole lift install, and coil over install.
Keep tuned folks! By the time these are here, and I get to installing. Will most likely be end of September.
Once all is completed, and here.
I will be doing a big, picture intensive write up on whole lift install, and coil over install.
Keep tuned folks! By the time these are here, and I get to installing. Will most likely be end of September.
I've never heard of this before either. That's awesome, def might havta look into that in the future :hmm:
Installed tows tonight, added some in-line fuses for my HID harnesses, set all tire pressures @ 42 PSI, and got truck ready for exhaust appointment in the morning!
seemed like a fair number. fronts had 42, rears only had 20 for some reason.
whats an ideal PSI for these tires (E rated) for a 1/2 ton?
i normally run 40 in the front and 35 in the rear, because the motor adds weight to the front all the time.
I'll be hauling sled around for like 1000 km this weekend, so I will keep rears @ 42 PSI. Maybe I will drop it down to 35-37 when I'm back