If you don't know me, I'm Devin. I started off with a 2000 silverado 4x4 and in three years had it to a point where it was painted and dropped 5/10 on a set of 24's
The day I got it
A few weeks ago
The truck was then severely vandalized, and to be honest, it really pushed me over the edge with the truck. The people who vandalized it were found and I was reimbursed for my losses. Regardless I was sick of the truck and found a buyer.
Long story short I picked up an 01 2wd for really cheap
The plans for the truck are:
EKMW front kit to lay on 24's (purchased)
Accuair elevel (purchased)
8.5 gal tank
Airlift D2600's up front
Slam specialties RE-7's out back
24' ar894 rims 24x9 +38 (already owned)
255/30/24 tires
Flush mounting stock tranny crossmember (done)
Narrowing the rear end 1.75" per side
KP 6 link w/ watts upgrade (done)
Raised gas tank
Raise Y pipe
Roll pan (done)
Shaved tail lights
Shaved doors
Shaved third BL
Tear drop hot rod tail lights
Body cab (done)
Body core(done)
Body bed
One question,
I know a lot of people body drop a truck by moving the cab mounts down 2", then cutting 1" out of the cab and plating it with 1/4 for a 2 3/4 body drop. Is It possible to move the mounts down 2 3/4 and not have to cut and plate the cab? I've heard rumors that the bolt for the cab mount will end up dragging with the mounts moved down 2 3/4.
Thanks,
The day I got it
A few weeks ago
The truck was then severely vandalized, and to be honest, it really pushed me over the edge with the truck. The people who vandalized it were found and I was reimbursed for my losses. Regardless I was sick of the truck and found a buyer.
Long story short I picked up an 01 2wd for really cheap
The plans for the truck are:
EKMW front kit to lay on 24's (purchased)
Accuair elevel (purchased)
8.5 gal tank
Airlift D2600's up front
Slam specialties RE-7's out back
24' ar894 rims 24x9 +38 (already owned)
255/30/24 tires
Flush mounting stock tranny crossmember (done)
Narrowing the rear end 1.75" per side
KP 6 link w/ watts upgrade (done)
Raised gas tank
Raise Y pipe
Roll pan (done)
Shaved tail lights
Shaved doors
Shaved third BL
Tear drop hot rod tail lights
Body cab (done)
Body core(done)
Body bed
One question,
I know a lot of people body drop a truck by moving the cab mounts down 2", then cutting 1" out of the cab and plating it with 1/4 for a 2 3/4 body drop. Is It possible to move the mounts down 2 3/4 and not have to cut and plate the cab? I've heard rumors that the bolt for the cab mount will end up dragging with the mounts moved down 2 3/4.
Thanks,
Last edited: