TILLERS 2K16 Silverado build

Headers are on, they were a royal bitch to do by myself. Going to get the flex pipe thing cut off and weld a piece of pipe in there since I can't get it to seal up 100% and then tune tomorrow


Sent from my iPhone using Tapatalk
 
I fucking HATE that flex pipe thing. I dicked around for 20 minutes with my catback trying to get it to seal, the only part that took longer was letting the exhaust cool down enough to not melt my Mechanix gloves lol. I'm sure I don't have a perfect seal, but I'll tackle that whenever I decide to go with LT's.
 
Flex pipe or the slip joint on the crossover? Slip joints never seal good. Get them to weld in a vband instead.
 
Oktain said:
I wonder what a header install on a 4x4 is like lol
Click to expand...

The ones I did on my nnbs were equally a bitch.. but I had room to work when I pulled the wheel well liners unlike this one. The rear header bolt on the drivers side is going to suck when you do it


Sent from my iPhone using Tapatalk
 
I'm buying my 3/6 kit next week. I'm going to get a 255 55 20. I figure that's 1" taller than your tire but you are also 1" lower all around. You don't rub at all now do you?
 
Nasty said:
What kit number? The ones on mcg site say will not fit steel control arms. I have steel arm and spindles
Click to expand...

5f7ae4480999c4750497b8b9cb061621.png
the stamped steel or the cast steel?



Sent from my iPhone using Tapatalk
 
You must log in or register to reply here.
Top Bottom