Roll n lock for crew cab (possibly rc/ec beds)

Status
Not open for further replies.
Jared

Jared

Administrator
Feb 8, 2012
20,572
116
0
North Dallas
Found a local guy selling one for $400, if anyone is local and wants it let me know. I can go meet the guy and pay him, but you will need to meet me within a couple days to reimburse me.

IMG_7687.jpg

IMG_3879.jpg


his truck is a 2500hd crew
 
Last edited:
Then yes, I am awaiting for his part number. He said he would get it in the morning. He said he thought it was the 206m model. Which would fit rc and ec
 
Luis, I'm thinking it is too long for you. At first guy told me short bed, then I asked him which bed, what truck etc. Finally I got the CC from him, but it seems the CC HD has a longer bed.
 
Jared said:
Luis, I'm thinking it is too long for you. At first guy told me short bed, then I asked him which bed, what truck etc. Finally I got the CC from him, but it seems the CC HD has a longer bed.
Click to expand...

Well, shoot. Guess I'll keep hunting. Thanks anyway.
 
when me n eddie installed the rollbak g2 on mine...it looks as though it was for a 6'6 MAYBE 6'...but if its a longer one it should be able to stop short for a shorter bed. you just set where you want it to stop at
 
maybe, but I don't want someone assuming this would work, go buy it, then have them SOL when they try, and me have to reimburse them or have them turn around and sell it. Once I receive the text about the part number I will post it. He was suppose to get it to me when I made the thread, but he got caught up I assume.
 
krusn64 said:
when me n eddie installed the rollbak g2 on mine...it looks as though it was for a 6'6 MAYBE 6'...but if its a longer one it should be able to stop short for a shorter bed. you just set where you want it to stop at
Click to expand...

I've always wondered this but are the brackets that go on the bed rails adjustable?
 
the guide rails aren't adjustable, you'd have to cut them if you had a longer kit and put the end caps back on. the actual bracketry that secures it to the bed is but the rails would dictate what it goes on, and width obviously. there was a difference between the fit on my truck and when i swapped it over to a friends 03+ silverado. bed was the same length but width was actually off by 1/2 inch. made it really hard to adjust and get to pull back correctly
 
1/2 ton crew bed is slightly narrower than 6'6" bed, i tried dropping my tool box in my 04, thought maybe it was because the box is for OBS but dropped into an 03 6'6" bed no problems
 
I guess he decided to keep it, or sold it...I never got a response afterwards for the part number. So I am locking this.
 
Status
Not open for further replies.
Top Bottom