Detailing Equipment, Product, an Tips/Tricks Thread

My grandpa was original owner and he barley even washed it let alone detailed it. But that scares me I don't wanna leave it worse then when I started

Sent from my DROID2

that was an extreme example haha. dont worry too much, i highly doubt the clear is that thin, just keep your pad moving and u'll be fine
 
Ran my rotary today correxted alot of awirls but some still remain

Sent from my DROID RAZR using Tapatalk 2
 
I use a dewalt with 8" pads and 3M 3 step compounds. Then give it a hand glaze, call it dunz. ImageUploadedByTapatalk1336204422.885279.webp
Smooth like babies behind.
 

Attachments

  • ImageUploadedByTapatalk1336204422.885279.webp
    ImageUploadedByTapatalk1336204422.885279.webp
    22 KB · Views: 3
That depends if you want to embed the paint contaminants into your paint or not..if you do then dont clay...

I didn't :/ I was short on time and got impatient. Hopefully it didn't cause any harm. I'll prolly re-detail mine mid summer.
 
just wish I had more time to do any of our vehicles, it takes me like 3 hours from dragging everything out of the garage to finish drying, i've got a pile of adam's stuff and a pc that hasn't even been out of the box yet

how do I clean the pads when I'm done polishing, by hand? throw them in the dishwasher with my plates? let the dog lick them clean?
 
just wish I had more time to do any of our vehicles, it takes me like 3 hours from dragging everything out of the garage to finish drying, i've got a pile of adam's stuff and a pc that hasn't even been out of the box yet

how do I clean the pads when I'm done polishing, by hand? throw them in the dishwasher with my plates? let the dog lick them clean?

i use simple green to soak them and then rinse them out.
 
ive got some new products coming in on tuesday, anxious to try em out. will put up reviews on here after i do so