Bagged NBS Thread (99-07c) Pics & Discussion 123123
- Thread starter Zach.
- Start date
Thats what I was telling Joey this morning. Usually theres a crossmember or something connecting each side of the wishbone together.
The bed will be showing a nice cut out of the wishbone,notch and tubing
A notch cover will be built to cover and pull off at shows
The tank will be hidden,but coming off the tubbing work will be dual 480s floating at 45s ,along with all the accuair vu4 and speedbox mounted floating in the center. Just showing it off
,well the Viairs are a whoopie shit but the accuair will be nice.Wish i had some AZ's i found a truck on the web set up like this and really liked the idea
We are going to cut a hole straight through the notch and weld a solid peice of pipe through it to run all my air lines and wires.
It will have tubs in the rear and the bed will get linex asap when its done
Removed parking break and bending some new low profile brake lines,grinding ever thing off the axle like stock shock mounts,those bump stop plates,just to clean things up
A notch cover will be built to cover and pull off at shows
The tank will be hidden,but coming off the tubbing work will be dual 480s floating at 45s ,along with all the accuair vu4 and speedbox mounted floating in the center. Just showing it off
,well the Viairs are a whoopie shit but the accuair will be nice.Wish i had some AZ's i found a truck on the web set up like this and really liked the ideaWe are going to cut a hole straight through the notch and weld a solid peice of pipe through it to run all my air lines and wires.
It will have tubs in the rear and the bed will get linex asap when its done
Removed parking break and bending some new low profile brake lines,grinding ever thing off the axle like stock shock mounts,those bump stop plates,just to clean things up
here's the heims(2 of these)
Heim Joint 5/8" LH | Heim Joints | Suspension | Summit Machine
you'll need 4 of these
Heim Spacer 5/8" | Heim Spacers | Suspension | Summit Machine
you'll have to cut the 1" spacer to go on the heims out of tubing.
the sleeve for the tierods will have to be drilled and tapped, because they dont make a tube adapter with the thread count on the inner tie rods. At least at the time I did mine. I forgot what the thread count is but you can easily get that.
just remember to get some jam nuts for the hiem joints.
5/8". you'll have to drill the spindle out to be able to use this size bolt. you can either have it machined or get some cold roll steel and drill and tap each half of it. thats all I did
to anyone wanting Hiem steering adapters, I'm going to be making them upon request. They will be $75 shipped anywhere in the connecting 48. if you want heims, misalignment spacers, bolt and all. It will be $175 shipped anywhere in the connecting 48. will have some pics later this week when I get done making Peyton's.