Seat Riser kit NNBS 07-13 Crewcab

QuicksilverZ71

QuicksilverZ71

New member
Feb 21, 2013
355
0
0
I made a few extra kits as I made my own to raise my rear seat 2.5". You will get a little more than 10" at the front of the seat for clearance. This kit will come with a total of 8 pieces to raise the seat along with the seat belt mounts and all the hardware that you will need. Bolts and nuts are grade 8. Steel risers are .125 steel. $125 shipped in lower 48 states. PayPal accepted.
a2uvude7.jpg
ejumuvup.jpg
ma9ubybu.jpg
pysu6ute.jpg
 
utyrabus.jpg
e7aqarut.jpg


You will get roughly 11-12" of height at front of box (11.25" shown) and 7" at the rear. This is a test for box that I built just to size seat height. Starting my build tomorrow. 2 10" L7 This box will net roughly 1.5 cube for each sub.
 
Last edited:
I have seen a few out there. Do a search and you are sure to come up with a few hits. If I had a NBS around I would make one for it. I thought more people would want one for the nnbs but I have yet to sale the kits I made up?!
 
You must log in or register to reply here.
Top Bottom