I have a 2013 ex cab short bed and right now I have a 4/7 drop with 22 inch tbss wheels. I am wanting to go down to a 6/9 or 7/10 but I know that I need to go to a 2 piece shaft but wasn't sure what I need to get one from and what all I need to do it (ie. crossmember or make one) Any help would be appreciated. I don't live near where anyone goes this low static to look at others trucks or anything!
NNBS 2 piece drive shaft question for lowered truck
- Thread starter 1lo94
- Start date
making the cross member is easy and cheap. I used 2" x 2" square tubing and a peice of 3/16 to make mine.
Set the angles and center the shaft then weld it in. Drill your holes to bolt the carrier barring on. Check my build thread i have a few pictures of mine somewhere in there
Set the angles and center the shaft then weld it in. Drill your holes to bolt the carrier barring on. Check my build thread i have a few pictures of mine somewhere in there