were is everyone getting them for a 03^^ an are they junk like the one that were made for the 88-98 that leaked an held mousture??
heat gun/oven and a butter knife, screw driver and clear silicone
fuck the plastic clear obs headlights! crystal clear glass headlights :fuckyeah:
the NBS body style 99-07classic do not look good with the painted inside, plus you will loose a TON of light output.
if you look around atleast 66% of the trucks here have factory cleared headlights.
my prefered method is to get a heat gun, and heat up all the way around the light,
then focus on one section, dont get it hot to the point that the plastic is soft, your goal is the get the factory glue soft, not the plastic,
stick the butter knife inbetween the sections and gently pry appart, if its supper hard still try a little more heat.
work your way around the headlight until it comes appart. **DO NOT TOUCH THE CHROMED PART, YOU WILL NEVER GET IT CLEAN AGAIN**
Then the orange reflector just kinda pops out, take your silicone, and put it on the housing where the 2 connect.
then put the lens back on and press firmly. use your finger to wipe away any excess silicone from the outside.
This is when you need something heavy, i used a bunch of books to keep pressure on the lens for around 24 hours, allowing it to cure all the way.
then reinstall.
same goes for the parking lens on the 03-07
*NOTE* The only parking lens that can be cleared are the 03-07 silvy ones. if you have a GMC or a 99-02 silvy, you will need to buy the lens.