06 ecsb 6.0/80e swap skreet truck build

Moore

New member
Feb 12, 2012
1,136
227
0
31
Maryland
Ok boys we gonna build a cammed 6.0/80e skreet truck.

Here's da plan:
06 6.0
01 gm reman 4l80e
Lsxap Cam(227/231...blah blah forget the rest)
PTC single disc 3200 converter
Speed eng headers
Atomic fab and performance coilover setup
Rear relocated shocks with DA vikings
Rear helper bags


Ok here's the truck

7Vc0OPc.jpg


u3biSWX.jpg



Motor and trans chillin for now

by18s3p.jpg



AFP brackets, viking coilovers

PBYdbjD.jpg


6PBMY8y.jpg


Various pictures of coilover install, switching from ridetechs and also installed mcg 16 inch spindles which was a huge pain in the ass.

48ImBTD.jpg


D0Qde2A.jpg


AOMOuXU.jpg


gV8q72Q.jpg


KJx1F2B.jpg


DAT NEW NEW 4 U

JZPkrNJ.jpg




Ok that's where we left off, picking it up tomorrow from the chop shop getting alignment so I'll have ride height pics then. Waiting on cam and converter to get here for the 6.0 and 80e swap to begin. Honestly pretty intimidated because previously ive only ever done swaps on hondas and dumb shit like that but we'll see how it goes.

So far I have a 80e conversion crossmember, yoke, u joint, and harness, just waiting on converter

Questions? Comments? Concerns?
 
Fuckin a this thing is gonna be the tits. You'll probably have this done before mine and Dan's :rofl: though mine is ready to schwing right now.

Camb is very similar to mine, should do well in there. Who is doing the tuning?
 
  • Like
Reactions: TechieTruckGuy
Fuckin a this thing is gonna be the tits. You'll probably have this done before mine and Dan's :rofl: though mine is ready to schwing right now.

Camb is very similar to mine, should do well in there. Who is doing the tuning?

If all 3 of us don't have our motors done by Carlisle, we fucking failed.

I just finally got my motor into MY garage tonight, tear down starts tomorrow.
 
  • Like
Reactions: Khaos and DeanH1290