You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
Dropped the wheels and tires off somewhere in there to get the 35s mounted
Played with different stacks of washers trying to get...
-
Painted these little filler pieces while I had the bumper off
Had to cut the bottom 90 off the front bumper to frame brackets
And...
-
Guess I should update this now that I'm basically finished lol.
Once I got done with the front suspension, I cranked the bars what I...
-
I've always cleaned and painted the frame on all my trucks, usually takes a weekend or two and I use a combo of wire brushes in a drill...
-
So I started about 5pm yesterday tearing it down. This truck is completely rust free but there's just dirt and mud caked everywhere...
-
So last night I decided I wanted a break from the engine stuff and started on the front suspension. I'd bought all this stuff 6mo ago...
-
So then yesterday I double and triple checked the harness, put the air box/intake tube back in and plugged in the MAF. Hooked up the...
-
So Tuesday night after work I started buttoning all the other little details up. Started with the valley plate, got new knock sensor...
-
Made small but important progress yesterday. Crawled underneath and measured my gap from the converter to the flexplate with a drill bit...
-
Then got it swung up in the truck
Slowly...
Slowly...
Had to do some sketchy shit to get the hoist to come all the way out...
-
So then last Thursday I put the pushrods and lifters in
Got all that torqued down properly, installed the GM valve cover gaskets...
-
So that night, I ordered some ARP head bolts and also the driver's side frame side engine mount cuz I'd broken 2 bolts off getting it...
-
Didn't do anything yesterday except getting the C10's alternator warrantied. Just wasn't happy with the paint color on the motor so I...
-
Did the VCs too of course
So while those were drying, I pulled the driver's frame side of the engine mount out. 2 of the bolts had...
-
Dropped the pan on, put the bolts in loosely and aligned it with the straight edge as well
Then set it out in the sun to start...
